Bronica S2 light leak

[negativefunk]

Hi all,

I took a sample roll with a Bronica S2, and while it all seems nicely working, there is some apparent darkening in the negative between the frames.
It does not seem to affect the pictures, an it happens regularly (intensity varies somewhat, this is the point where it is most apparent).

As I am not planning of keeping it, I would like to know why it happens, if someone has a clue, in case it is something I can remedy

 

[Don_ih]

There might be light sealing material behind this plate:

that has disintegrated. The light must be from either the top or bottom of the film back, at the edge where that plate joins the shell.

 

[negativefunk]

Thanks Don, another forum member suggested the same thing and it makes sense. I'll have a go at replacing it there.
It turns out that most pictures focus did not fall where intended so I think I have to replace also the foam where the focussing glass rests, it seems a common problem.

I'll update once I run a new roll with these two things fixed!

 

[Don_ih]

Good luck! I only know one person with one of these cameras and he's had an endless stream of problems with it. Hopefully, yours does better than his.

 

[reddesert]

First, also make sure the back is fitting tightly against the body.

IIRC, you can take off that front plate of the back by removing the many small screws around the edge. If this back has the safety roller blind curtain that is pushed across by the darkslide, watch out as it may go sproing! and roll up.

 

[reddesert]

There's also some felt at the back door of the back, both near the hinge and near the latches. Check the condition of that. Although not obviously at the right place for such a leak, the fact that the leak is outside the frame and runs across the full length left-right of the film, suggests that it could be coming from somewhere behind the film gate, and perhaps somewhere that runs across the film rather than along it (like the back door, but not like the darkslide slot). The behind-film-gate tends to rule out my suggestion of a loose fit of back to body, but that's an easy thing to check anyway.

 

[itsdoable]

That is light leaking around the other side of the film rollers. On that back (Not the insert) there are thin rollers at the top and bottom. The bottom roller leaks light sometime when there are internal reflections or lots of sky lighting up the bottom of the film gate, allowing some light to scatter between the film gate and roller to the other side.

Light scatters behind this roller.

This happens with Hasselblad film backs too.

If you are seeing this a lot, check for internal light reflections or missing baffles, and/or use a lens hood to limit the amount of light that is not part of the image.

 

[Smilin' Vic Coln]

Hey negative funk, were you ever able to solve this issue? I'm experiencing a very similar issue and I also have those light leaks between frames.

 

[Smilin' Vic Coln]

That is light leaking around the other side of the film rollers. On that back (Not the insert) there are thin rollers at the top and bottom. The bottom roller leaks light sometime when there are internal reflections or lots of sky lighting up the bottom of the film gate, allowing some light to scatter between the film gate and roller to the other side.

View attachment 374133
Light scatters behind this roller.

This happens with Hasselblad film backs too.

If you are seeing this a lot, check for internal light reflections or missing baffles, and/or use a lens hood to limit the amount of light that is not part of the image.

Do you know of any fixes?

 

[itsdoable]

Do you know of any fixes?

No - that's just the way it is.

However, the light leak you are showing on the previous post is likely not from the design of the rollers, which usually stays in the rebate, and only by the rollers. The leak you are exhibiting is all around the frame, and is probably coming from somewhere else. Can you show the whole negative, including the rebate and neighboring images?